So hopefully, we now have everything we need to get the Fuso out. In addition to Jon and me, we also have:
Carman, of Smith n Tobey Recovery Services, and his Xterra
and the highly skilled and experienced Willie of Courtney Rock and Transport and his assistant, Gary. Willie has brought his bulldozer, mini excavator and a tan pick-up truck with equipment.
It is currently 12:30 in the Black Rock Desert playa and temperatures are already at 100 degrees Fahrenheit.
We started by walking around the Fuso, evaluating and discussing its current situation.
Note how well you can see the underside of the Fuso. This is not a good way to view our vehicle.
It was decided to try to level the Fuso. We didn’t want it to fall over on its side and having all four tires on the ground makes it more likely it would be able to roll rather than drag.
The first task involved using the excavator to dig a hole next to the driver’s side rear wheel.
Jon and Willie attached arecovery chain to the frame.
The Bulldozer was moved into place and the recovery chain was hooked up. When the bulldozer was drove backwards, the Fuso slid into the hole and straightened out.
A deep hole had been required.
The Fuso is now quite a bit more level.
Now there is a big gap on the passenger side of the Fuso between it and the ground. The excavator was used to fill in the gap.
The bulldozer was moved to the back of the Fuso. The Fuso was hooked up to the bulldozer. We are trying to pull it backwards.
The Fuso has not moved backwards at all.
There is too much dirt behind the rear wheels. To get the Fuso to roll backwards, it will need a ramp.
Clearing out the dirt under the back of the Fuso.
At least by having the excavator, it makes it much easier to dig an area next to the truck to work.
As always, there is lots of digging required.
While Gary and Carman were digging under the back of the Fuso, Jon and Willie had been discussing the situation.
The ultimate problem is getting the Fuso up and out of the hole. So Jon and Willie decided to see how effective the excavator is at lifting the front of the Fuso.
It wasn’t successful. The Fuso is just too heavy for the mini excavator bucket to lift.
Since more of the dirt had been cleared from the back of the Fuso, we used the bulldozer to attempt to get the Fuso to go backwards.
The bulldozer dug in and the Fuso didn’t move at all.
Willie had a big tow rope that we hooked up to the back of the Fuso in hopes that it would provide enough dynamic power to yank the Fuso enough to get it moving.
Even with that effort, the Fuso remained firmly stuck.
Video of Bulldozer trying to pull the Fuso backwards with a tow rope
A new approach was needed. Instead of pulling forward or backward, we would try pulling it sideways to try to get more of it on less disturbed/firmer ground. Since the passenger side was the low side, they started by pulling on the frame next to the driver’s side rear wheel.
After hooking it up, the bulldozer gave it a tug. It slid over several inches.
The tow chain was attached in front of the driver’s side front wheel. The same process was tried again. The front of the Fuso slid over quite a bit more.
(Please pardon the quality of the video, everything was happening so fast that I hard a hard time photographing and video taping the events.)
Now that the Fuso is reoriented, the next effort was focused on pulling the Fuso forward. Jon and Willie hooked up our recovery chain to the front of the Fuso.
The bulldozer gave it a tug. The tow chain broke.
Video of pulling the Fuso forward and the tow chain breaks
Jon and Carman crawled down to extract the broken pieces and to see if there had been any damage.
The recovery chain belong to us and was obviously not rated for this kind of effort. Another chain was brought from Willie’s supplies. In addition to another chain. We decided that it would be helpful to dig out from in front of the front tires to give them a little more of a ramp to climb up.
So more digging occurred.
Finally we were ready to give it another try pulling forward this time.
Four days after we got stuck in the Black Rock Desert playa, we finally had the Fuso out of the hole we had sunk into.
However, this is not the end of the day or the story. It wasn’t enough just getting the Fuso out of that hole, we had to get it back on a firm surface.
I’ll continue in the next post.